1. A bare printed circuit board. This is a high quality double-sided board with plated through holes, soldermask, and silkscreen.
2. A programmed 27128 EPROM containing the operating program.
3. A UA78S40 switching regulator chip.
4. An MC145411 bit rate generator.
5. An AD557 digital to analog converter.
6. A programmed PAL for address decoding.
7. A disk containing the documentation manual and software. The manual has instructions on assembly, usage, and troubleshooting; plus parts lists, and appendices with lots of valuable information.
8. Printed schematics for LP110 and personality modules.

In addition to the partial kit shown above, the following parts are required to finish the LP110. These parts may be purchased from various suppliers.

  Quan.   Part
------------------------------
Semiconductors
    1    1N5818
    1    2N3904
    3    2N2907A
    1    TIP30
    1    MAX232
    1    6264
    1    62256
    1    6803
    2    6821
    1    7407
    1    74HC14
    1    74HCT573

Capacitors
    2    15p
    1    560p
    6    0.1u
    5    10u, 16V
    1    22u, 50V

Resistors
   12    0.25W, 5%
    4    0.5W, 5%
    1    1K 3/4" trimmer
    3    8-pin networks

Sockets
    2    14 pin
    4    16 pin
    2    20 pin
    3    28 pin
    3    40 pin

Misc.
    1    Power terminal connector
    1    DB-9S connector
    1    22/44 edge connector
    1    100uH coil
    1    3.6864MHz crystal